Complete pack of positive rivets for P-38 F/H LIGHTNING for the 1/32 Tamiya kit

INSTRUCTIONS

1. Clean the model surface with wet cloth. Optional undercoat is Mr. Surfacer 1000 or Base White.

2. Cut each design out of decal sheet and dip them in warm water (30 - 40°C) for 10 - 15 seconds.

3. Check with finger tip if design loose on base paper. If so place it in proper position on model and slide of base paper leaving just the design.

4. Apply Mr. Mark Softer for undercoat. Move design to exact position with wet finger tip and push out excess of Mr. Mark Softer, water and air bubbles which are under the decal - use soft cotton cloth.

5. Let the decal dry for cca 2 hours.

6. Unstick the foil carefully and wash marks caused by transfer glue.